TX-NR609 won't power on after failed FW update
2 posters
Page 1 of 1
TX-NR609 won't power on after failed FW update
I have had my 609 for a few months and it was worked very well until today.
I attempted a firmware update using the on-board net updater. It said it would take about 60 min, so i went and got some food. When I came back the 609 showed "FLASH WRITE ER".
I looked through the manual and couldn't find anything helpful for this error, but it did say to unplug and try again... So i did, but when i tried turning the unit back on, it would not power up at all, no lights, nothing... The unit does make a click when I plug it in, but nothing else.
I attempted the hard reset, which did not solve anything.
I have looked online for this error but I cant find anything, so I am asking here for help before I call support.
Thanks
I attempted a firmware update using the on-board net updater. It said it would take about 60 min, so i went and got some food. When I came back the 609 showed "FLASH WRITE ER".
I looked through the manual and couldn't find anything helpful for this error, but it did say to unplug and try again... So i did, but when i tried turning the unit back on, it would not power up at all, no lights, nothing... The unit does make a click when I plug it in, but nothing else.
I attempted the hard reset, which did not solve anything.
I have looked online for this error but I cant find anything, so I am asking here for help before I call support.
Thanks
redward333- Posts : 1
Join date : 2012-04-21
Re: TX-NR609 won't power on after failed FW update
Hi redward333,
Unfortunately you will need to take or send this unit in for repair. Authorized service centers can be found on our website at www.onkyousa.com under support.
Unfortunately you will need to take or send this unit in for repair. Authorized service centers can be found on our website at www.onkyousa.com under support.
Similar topics
» New Onkyo TX-NR818 wont power on with remote
» TX-NR509 Update Failed
» TX-NR509 Failed update, now no sound or initialized USB/Net
» TX-NR609 Power Problem
» Any way to power a third zone on TX-NR609?
» TX-NR509 Update Failed
» TX-NR509 Failed update, now no sound or initialized USB/Net
» TX-NR609 Power Problem
» Any way to power a third zone on TX-NR609?
Page 1 of 1
Permissions in this forum:
You cannot reply to topics in this forum
|
|