TX-NR609 zone 2 volume

I have zone 2 hooked up to my outdoor speakers (8 ohm) using 14ga wire. I have to turn the volume way up at the receiver to hear the speakers load enough. Is there a way to adjust this? Thanks.

Hi dsartoris,

If the speakers are directly connected to the zone-2 connections on the rear of the unit and not going through and other amps then it is normal. The only way to increase the volume of the individual speakers is to make that adjustment in the menu. Go to setup => speaker setup => Level calibration. Keep in mind that this will increase the volume of the speaker selected.