Volume Control for Zone 2 on TX-NR 616

I have finally gotten my Zone 2 speakers to play via Onkyo M282 amp, but the volume is blaring loud. Following zone 2 volume instructions in the manual is not yielding the results I'm looking for. Any suggestions to controlling zone 2 volume?

Hi tjmurray17,

On the rear of the M-282 have you tried to decrease the "input level" you would normally set it to max but in your case it may need to be lowered. Please let me know if this works.

Thank you,

Forum Moderator.

Thanks! Adjusting the input level on the amp definitely helped, and makes my zone 2 area usable. It still doesn't allow me to alter the volume though. Is there anything else I can do so that I can adjust the volume the the receiver?

Hi tjmurray17,

Unfortunately there is not as the receiver output can not be adjusted.

Thank you,

Forum Moderator.