TX-SR606 receiver shuts down during playback over HDMI source

View previous topic View next topic Go down

TX-SR606 receiver shuts down during playback over HDMI source

Post  Kernel_thai on Wed Sep 26, 2012 1:20 pm

Im having a problem with my 3 yo tx-sr606. During playback of blu-rays from my Sony BDP-550 the receiver will shut down completely. The problem only seems to occur with an HD audio source. I am trying to see if this is a simple problem before I investigate expensive repair or replacement of the unit. Thanks for your help.

Kernel_thai

Posts : 1
Join date : 2012-09-26

View user profile

Back to top Go down

Re: TX-SR606 receiver shuts down during playback over HDMI source

Post  OnkyoUSA on Wed Sep 26, 2012 1:57 pm

What is the volume of the receiver before this occurs? Does this occur during loud explosion scenes of a movie? It could be that there is a frayed speaker wire touching the back of the receiver and when playing at a low level the speakers do not require that much power, however when the level from the speakers increases more power is required and if there is a frayed speaker wire touching the back of the receiver there could be a short causing the receiver to shut down. A way to avoid the frayed wire is to use "Banana Connectors" that the speaker wires goes to and the connector will plug into the speaker posts. Please try the following to see where the issue is coming from. Have the receiver turned off, make sure all the speaker wires are labeled, and disconnect them from the speaker terminals.
Turn the receiver on select a source that would give you sound if the speakers where still connected and turn the volume all the way up. If the receiver shuts down than it would need to go to a service center as it is an internal problem with it. If the receiver does not shut down, turn the volume down, shut the receiver off and connect one speaker and than turn the receiver on selecting the same source as before and raising the volume up. If the receiver shuts down, remove that speaker from the post and connect it to another speaker post to determine if it is the receiver or the speaker itself that is giving you the problem. If the receiver should shut down after moving that speaker you know it is a problem with the speaker or the wiring. If the receiver does not shut down, turn the volume down, shut the receiver off and connect another speaker followed by doing the previous test procedure. Keep adding speakers until you have them all reconnected to the receiver as long as it has not shut off while trying the test procedure. After determining whether it is the speakers or the receiver you would need to bring either to a service center to be repaired. To locate an authorized independent service center, check the dealer and service locator at our website: www.onkyousa.com or www.integrahometheater.com.

Forum Moderator
avatar
OnkyoUSA
Admin

Posts : 4077
Join date : 2011-10-06
Location : New Jersey

View user profile http://onkyoproductsupport.forumotion.com

Back to top Go down

View previous topic View next topic Back to top

- Similar topics

 
Permissions in this forum:
You cannot reply to topics in this forum